MSMAware Computation

Step 1: Perform “Storm” tutorial procedure using given sample data.

 

Step 2: Result of the Storm will be shown.

 

Step 3: Perform “Rational Method” tutorial procedure using given sample data.

 

Step 4: Result of “Rational Method” will be shown.

 

Step 5: Click “Detention Basin”

Step 6: Click and change version MSMA into MSMA 2000

 

Step 7: Click and change Inflow type into “RM”

 

Step 8: Insert all relevant data in “Pond Setting” group.

 

Step 9: Choose “Contour” type as “USER”.

 

Step 10: Insert all relevant data in “Pond Times” group.

 

Step 11: Insert all relevant data in “Outflow structure” group.

 

Step 12: Select relevant site condition for Pre and Post

 

Step 13: Click “Pre Post Setup”

 

Step 14: Click Button “Build” and carry data from previous chapter will be appear

 

Step 15: Select IDF design choose for Detention Basin for Pre and Post

 

Step 16: Select “Outlet Structures” and click button “+” to select orifice as outlet.

 

Step 17: Fill the relevant data base on sample data for orifice

 

Step 18: Select “SOF” tab.

 

Step 19: Insert data for surface area for each elevation.

 

Step 20: Select “Data” Group and click button Run.

 

Step 21: Result of Detention Basin will be appeared

 

Note 

 

 

Back : Computation in MSMA (2000)                          Next: Manual Calculation

 

 

 

Print This Page Print This Page

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website